Discussion in 'On Topic' started by 3x, Jan 7, 2010.
My first time assembling a lower
Don't forget the big ass ziploc for the detents
I'm going to use a plastic bag
Did that, ONCE lol.
Take your time and get a good punch for the roll pins. You can use tape to cover areas you may scratch while tapping in pins.
http://www.bravocompanyusa.com/ar15-Pivot-Pin-Installation-Tool-p/tool pivot pin install tool.htm
i used a utility knife like it shows in this video
fs: magazine release
I almost shit myself with laughter . I'm sure that'll be me this weekend when i assemble my complete lower.
I raged so hard when I lost the front detent
If you put it in without any scratches you're doing it wrong.
its like re-living it all over again
it wasn't too hard to me. the hardest part was probably the front detent...until i found a utility knife.
it took me 5 minutes to figure out what the hell they were talking about when putting the hammer in
well i meant the mag button and spring
it was a joke
I found mine about 6 months later, when I moved a chair and it fell out of the armrest
FUCK. I LOST THE DETENT SPRING CAN YOU FUCKIN BELIEVE IT?
oh well its a.65 cent part and i need to order some more stuff.
Navvik-1 blood rage-0
i lost and found detents three times, twice with the buffer detent
and i lost and found two springs, messed one spring up and had to cut it short
good luck bro
You guys are not instilling confidence in me about building mine up soon.
I actually shot myself in the eye with my detent, was not fun. Hurt like hell.
that utility knife trick really does help though. when i actually tried it it went in on the first try
Everything is usually pretty easy until you try to get the stock on
LOL... insult, meet injury
I didn't follow the directions. I should have used the knife method. Instead I thought I had a better way. I was wrong
100% Never have found the detent or the spring.