Discussion in 'That'll Buff Right Out' started by trayfoe, Jan 26, 2003.
sorry for the few blurry pics, no tri-pod and shakey hands suck.
I'm surprised to say this, but I like it. Is the ride harsh? It's so low.
are you the same guy who posted his saturn before but it was on spoon rims or somethign? and you were gonna turbo it? If not, the guy had the same CF trunklid or whatnot
Are those the TE-37 special editions? very nice..... I miss my TE-37s
mods list? looks good for a saturn otherwise
Don't drive with it that low, raise it up about an inch or so.
Yeah its the same car, but it was stolen and the wheels and half the other shit I had was stolen too. It was turbo and will be again, but the funny thing is its not money that is holding me back, its time. I work from 10am to 10 pm just about everyday and when you buddy that is going to do all the fab work lives in Orlando it kinda sucks. But I will definetly have pics of the new turbo setup as soon as its done. Yeah they are the LE-37t's, I like them a lot, look awesome and don't weigh shit
volk LE-37t's (AVS ES100 tyres)
powerslot rotors (front) stillen crossdrilled (rear)
Just waiting on brackets to be fabed for the wilwood 12.2" rotors and 4pot calipers.
Stainless brake lines
ARP 2.5" lug studs (front)
Skunk2 Aluminum/Magnesium lug nuts
1.25" wheel spacers (rear)
92 header with 2.5" exhaust and Apex N1 muffler (was for the turbo)
Brake ground cable kit
MSD coil packs with KV-85 wires
Shiftdown fuel rail with -6an stainless fuel line with Earls fittings and SARD Boost dependant FPR
Shiftdown EGR block off plate
Brake full aluminum radiator with dual 10" proform fans
Schroth 4 point harness's
Sparco ring wheel, shift knob and bronze pedals
Ichibahn black leathe shift boot
Defi A/F gauge
Razo 300mm rear view mirror
Carbon fiber laid over my stock mirrors
A little stereo stuff and some other shit that is just waiting to go in like the new turbo, SPS flywheel, the rest of the gauges, spearco intercooler, HK$ ss BOV, Tial 40mm wastegate, Garage Advance SS manifold, Haltec E6K and some other shit, should be fun when its done!
You seem to be serious about boosting the Saturn motor. The only way to go is with a stand-alone, and you got that covered! Good luck and keep us posted!
hes already had it boosted once before and didnt blow it
I loooove those rims!
pics r gone i wanna see
You can boost a lawnmower and not blow it up... big deal, he probably didn't turn up the boost
Nope, 4psi last time, 8.5psi this time on the same motor. Then the Haltec and try for 15psi, if it lets go then the built motor should be done (I hope) and then tune it right for 20psi.
you said "IByoublowthe1.9withboost" you didnt say how much boost so i was just stating hes had it boosted before.
damn that looks badass